calpeda NCM450-60/280  motor and pump form a single unit without a shaft seal, this design uses two seals to prevent fluid from flowing to the rotor.

In-line pump casing with suction and discharge pipelines in one line (multi-row version). All parts and bearings of the pump are lubricated by the pumped liquid. Minimal inlet pressure should be maintained to prevent cavitation.

Apply

Pumping of clean, uncontaminated liquids that do not contain abrasive inclusions and do not come into contact with pump materials (solids content Max.-0.2%). It is applied in circulating systems of heat supply, conditioning and cooling. It is used both in household and in industrial spheres of a national economy. Modification: NC - single pump; NCD is a dual pump.

Specifications

• Liquid temperature: -15 to + 120 °C. short-term - 140°C.
• Ambient temperature: up to + 40°C.
• Maximum amount of glycol: 50%.
• Maximum case pressure: 6/10 bar
• Minimum inlet pressure: 0.3 bar

Materials

• Body: : cast iron GJL 200 EN 1561, bronze G-Cu Sn 10 EN 1982.
• Impeller: stainless steel AISI 303, AISI 316, Cr AISI 430.
• Shaft: stainless steel AISI 303, AISI 316, Cr AISI 430.

Electric Motor

• Async onion 2-pole electric motor 50 Hz, n=2900 rpm. (with manual speed change 1-2-3)
  • NC, NCD: three-phase - 230/400V (±10%);
  • NCM, NCDM: single-phase - 230V (± 10%);
• Asynchronous 4-pole electric motor 50 Hz, n=1450 rpm. (with manual speed change 1-2-3)
  • NC4, NCD4: three-phase - 230/400V (±10%);
  • NCM4, NCDM4: single-phase - 230V (± 10%);
• Insulation class: "H"
• Protection class: IP 43
• Construction according to IEC 60034.
• Special versions IP 55, 60Hz on request

pump calpeda NCM450-60/280

pump calpeda NCM450-60/280